WEDA D10N (60Hz)
The WEDA drainage pumps handle either clean or sand-laden water, even with small solid particles, with the best performance and efficiency and with the highest power to weight ratio. These pumps are particularly suitable for general dewatering applications, ground water, raw water, construction sites and harsh conditions on site.
Technical Details
Solids handling, strainer hole
0.16 in (4 mm)
Liquid temperature
Max 104°F (40°C)
Depth of immersion
Max 65 ft (20 m)
Max liquid specific gravity
1.1
pH of the pumped liquid
pH 5–8
Portable drainage pump
Installation
N - Normal Head
Hydraulic range
F (+155°C/+311°F) IEC 85
Insulation class
IP68
Protection class
Max ± 5% of nominal voltage
Voltage variation
Max 2% - between phases
Voltage imbalance
Max 30 starts / hour
Max start-stop
H07RN-F (20 m) or SOOW AWG (65 ft)
Cable
Corrosion resistant aluminum
Casted parts
High chrome iron, 55±5 HRC
Impeller
Rubber (NBR)
Wear parts
Hard sole - reinforced polyethylene
Strainer
Stainless steel
Shaft
Rubber (NBR)
O-rings
Single row ball bearing in oil
Main bearing
Primary + secondary: grease lubricated lip seal on WC wear sleeve
Mechanical seal
1 ph: capacitor + contactor 3 ph: contactor + control relay
Built-in controls and protection
140°C / 284°F
Thermal contacts
Float switch
Zinc anodes
Epoxy coating
Low suction collar
Options / accessories
Quick couplings (hose / NPT / ISO-G / Camlock / Storz) Pump raft
Terminal board
NSSHÖU screened cable
Dimensions
Discharge connection
2 in
15.6 / 18.5 (115V) in (395 / 470 mm)
Height
8.9 in (225 mm)
Width
7.3 in (185 mm)
Diameter
29 ft (13.0 m)
Weight
Performance Curve
Power Rating
Motor rating
1 ph
3 ph
Std Cable
1.4 kW
Power P1
1.8 kW
1.5 HP
Power P2
1.5 HP
3500 r.p.m.
Shaft Speed
3500 r.p.m.
16.2 A
115 V
AWG14
8.1 A
230 V
4.6 A
AWG16
2.3 A
460 V
AWG16
1.8 A
575 V
AWG16